EKO MP-11 - Safety Information; WARNING;CAUTION

EKO INSTRUMENTS CO., LTD. I-V Curve Checker MP-11 Instruction Manual Ver.7
Pg. 5
3. Safety Information
EKO Products are designed and manufactured with consideration for safety; however, please make
sure to read and understand this instruction manual thoroughly to be able to operate the instrument
safely in the correct manner.
WARNING
CAUTION
Attention to user; pay attention to the instructions given on the
instruction manual with this sign.
HIGH
VOLTAGE
WARNING
High voltage is used; pay special attention to instructions given on
this instruction manual with this sign to prevent electric leakage
and/or electric shocks.
3-1. WARNING/CAUTION
1. Handling
 DO NOT use MP-11 for other than its original purpose.
 DO NOT disassemble, modify or touch inside of MP-11.
 Check the main supply voltage corresponding to the voltage requirements of the MP-11 power
adapter.
 Use ONLY the AC/DC adapter, which is assigned to the MP-11. Using other types of power
adapters will cause potential risk for damage. EKO will NOT take responsibilities in case of
damage or accidents occurrence with use of cables other than attached to MP-11. Data taken with
other cables will NOT be assured.
 Make sure that the connection terminals and cables used for connecting PV
modules/strings/arrays satisfy their rating capacity
 Connect probes securely so that they will not easily come off from the terminals.
 DO NOT connect to PV strings/arrays, which exceed the rated maximum voltage 1000V, current
30A, and power 18kW.
 To avoid the risk of damage, switch ON the MP-11 power first, before connecting the PV
module/array to be measured, and disconnect the PV module/array before turning OFF the MP-11.
 Disconnect power conditioner or inverter, before connecting MP-11 to PV module/string/array.
 Switch ON MP-11 before connecting to PV module/string/array
 Disconnect PV module/string/array before Switch Off MP-11
 If you notice any smoke or odor from MP-11, turn OFF the power immediately.