EKO INSTRUMENTS CO., LTD. I-V Curve Checker MP-11 Instruction Manual Ver.7
1) Date & Time Setting
When [DATE & TIME SET] is selected from the System Menu screen, date and time setting screen
appears. The Main Unit date and time can be setup from this screen. Use Left/Right buttons and the
numerical buttons to adjust the date and time.
[DATE] YYYY/MM/DD
[TIME] hh:mm:ss
2) LCD Contrast Adjustment
When [LCD CONTRAST] is selected from the System Menu screen, the LCD contract adjustment
screen appears.
Use Left/Right buttons to adjust the LCD contrast to your desirable
contrast.
3) Loading Sensor Unit Data
When the measurements were taken without connecting the Main Unit and the Sensor Unit, the Sensor
Unit data must be downloaded to the Main Unit by connecting each other with modular cable.
Connect the Main Unit and the Sensor Unit with modular cable then turn ON the Sensor Unit power.
Select [LOADING SENSOR DATA] on the System Menu screen to download the Sensor Unit data to the
Main Unit.
The data loading status can be monitored by the indicator and counter.
※ The Sensor Unit measurement data should be downloaded to the Main Unit within the day of
measurements taken. Although the data recorded by the Sensor Unit has time information, they
are not provided with date information. There may be some risks that the Sensor Unit data cannot
be loaded to the Main Unit or the data between the Main Unit and Sensor Unit may not match by
dates if the Sensor Unit data are loaded on another day.
Same problem may occur when the Main Unit and the Sensor Unit were synchronized with time
successfully.
Date & Time Setting Screen
DATE 2013/01/10
TIME 15:10:30
To Next Page
Loading...
