Installing by Wizard
The Wizard type installation automatically starts up the installation wizard when the USB connector is
inserted into the PC.
Depending on the PC environment, the wizard may not appear; in such case, the USB driver must be
installed manually from Device Manager. The device driver needs to be updated and reinstalled also
from Device Manager.
For further details, refer to the following URL for FTDI Ltd.
URL: http://www.ftdichip.com/Documents/InstallGuides.htm
For installation and updating the driver software in the wizard format, assign the following folder which is
in the attached DC-ROM for the original driver installation folder.
¥CDM v2.08.30 for Windows 8.1
2. Confirming Completion of USB Driver Installation
1) After the PC is restarted, connect the PC and
MP-11 Main Unit with USB cable.
2) Open the [Control Panel] from Windows.
3) Click the [System] icon. Click the [Device
Manager] which is in the System window.
4) Check the Port is assigned with USB Serial
Port (COM*). The COM number will change
depending on the PC environment.
5) Open the USB Serial Port property window
and verify there is a statement on the Device
status section as “this device is working
properly”.
Then finally the USB serial converter
driver and USB Serial Port Driver software
installations are completed.
To Next Page
Loading...
