EKO MP-11 - Page 61

EKO INSTRUMENTS CO., LTD. I-V Curve Checker MP-11 Instruction Manual Ver.7
Pg. 60
9-3. Software Operations
To operate the MP-11 from PC using this software, connect the MP-11 Main Unit and PC with attached USB
cable and turn ON the Main Unit power.
To start this software, go to [Start]  [EKO]  [MP-11].
When this software is started, the Main Window appears. There are 4 tabs [Measure], [Graph], [Save] and
[Irr. Vs Par.]. By clicking each tab, each tab display changes. When the software started the [Measure] tab
is displayed as default.
1. Measure Tab
On the Measure tab, measurement parameter can be setup and take measurements.
Each button function is described below.
Table 9-1. Measure Tab Functions
No
Functions
Details
1
Measurement Status Display
Indicate statuses of “Stop”, “Standby”, or “Measuring”
2
Load Data Button
Upload measured data from MP-11
3
Start Button
Start measurement
4
Stop Button
Terminate measurement
Figure 9-3-1 Measure Tab
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19