ekwb EK-Quantum Kinetic TBE DDC PWM Series - Page 7

- 7 -
The assembly can be mounted on any flat surface
inside your computer chassis. You must drill four (4)
4.2 mm holes using the power drill in a 50 x 50 mm
square pattern.
Please follow these steps:
- Screw on the Vibration Dampers on DDC Screws
- Drill four (4) 4.2 mm holes into the chassis
- Use enclosed M4 x 4 mm screws and PVC washers to
secure the reservoir to the chassis
CAUTION
Mounting holes pattern (Not in 1:1 scale)