Need help?Do you have a question about the ekwb EK-Quantum Volume FLT Series and is the answer not in the manual?
General| Series | EK-Quantum |
|---|---|
| Type | Reservoir |
| Material | Acrylic |
| Dimensions | Varies depending on the model (FLT 120, FLT 240, FLT 360). Refer to the specific model's specifications. |
| Ports | G1/4" threaded ports |
| Pump Compatibility | D5, DDC |
| LED Compatibility | Addressable RGB (5V) |
| Reservoir Type | Flat Reservoir |
Mount reservoir directly to chassis using included M4 screws at standard fan mounting locations.
Position the supplied FLT mounts as desired on the reverse side of the reservoir.
Screw the mounts into place using supplied M4x8 screws and a 2.5mm allen key.
Use M4 nuts, washers, and M4x10 screws to mount the reservoir directly to a fan.
Use 30mm radiator screws to mount reservoir with 25mm thick fans to the radiator.
Use shorter 5mm screws from the radiator to mount only the reservoir to the radiator.
Use M4 nuts, washers, and M4x10 screws with mounts to secure reservoir to a case.
Use one inlet and one outlet; block all 4 unused ports with G1/4 plugs.
Use two ports as inlet/outlet, connect outlet to pump, position reservoir above pump. Block unused ports.
To Next Page