Need help?Do you have a question about the ekwb EK-Quantum Magnitude and is the answer not in the manual?
General| Type | CPU Water Block |
|---|---|
| Material | Acetal, Copper |
| Compatibility | Intel LGA 115x, 1200; AMD AM4 |
| Inlet/Outlet | G1/4" |
| RGB Lighting | Addressable RGB |
| Connection Ports | 3-pin |
Lists compatible Intel LGA sockets for the 115X series.
Lists compatible Intel LGA sockets for the 20XX series.
Lists compatible AMD sockets for the AM4 series.
Lists components included for the EK-Quantum Magnitude 115X model.
Lists components included for the EK-Quantum Magnitude 20XX model.
Lists components included for the EK-Quantum Magnitude AM4 model.
Describes O-Ring usage in Magnitude blocks without D-RGB LED strips.
Unscrew four screws to detach the coldplate from the water block.
Replace the Jet Plate according to the specified socket table.
Unscrew four screws to remove the frame and other components.
Remove the current accent and install the new one.
Refit the O-Ring between Top and Accent if no LED strip is used.
Insert the LED strip into the frame and between the Top and Accent.
Position the frame onto the top, aligning curvature markings.
Replace the coldplate, ensuring correct orientation and screw tightness.
Unscrew four screws to detach the coldplate from the water block.
Choose the appropriate jet plate and align it correctly in the insert.
Replace the coldplate, ensuring correct orientation and screw tightness.
Unscrew four screws and remove the frame and coldplate.
Remove the O-Ring, Jet Plate, and Insert from the water block.
Place the Insert back into the Top in the desired orientation.
Refit the O-Ring and position the Frame, ensuring correct orientation.
Fit the Jet Plate and ensure it is correctly positioned in the Insert.
Replace the coldplate, ensuring correct orientation and screw tightness.
Prepare the motherboard and mounting mechanism for installation.
Remove factory clamps and backplate for AM4 socket installation.
Prepare the rubber gasket for 115X sockets by removing the inner core.
Position the rubber gasket and backplate onto the motherboard mounting holes.
Loosely install standoffs and plastic washers for 115X and AM4.
Prepare the motherboard and mounting mechanism for 20XX socket installation.
Install all four standoffs tightly into the ILM Heat Sink studs by hand.
Clean the IHS and apply a thin, even layer of thermal compound.
Position the CPU water block onto the standoffs after removing the protective sticker.
Insert all four springs inside the frame of the water block.
Loosely insert screws, then tighten in a cross pattern until flush.
Plug the 4-pin D-RGB connector into the correct motherboard or controller header.
To Next Page