ekwb EK-Quantum Magnitude - Step 3: Install LED Strip; Step 4: Position Frame

- 10 -
STEP 3
STEP 3 (WITH LED STRIP)
First insert the LED Strip though the desired corner of the Frame and
then fit the LED Strip between the Top and Accent. When using a
Plexi Top the LED Strip should face inwards. When using an Acetal
or Nickel Top the LED Strip should face outwards.
STEP 4
STEP 4
Position the Frame on the Top paying attention to the orientation,
failure to do so will prevent installation of the Screws. The curvature
marking should be in line with the Jet Plate opening as illustrated.
Ensure that the Jet Plate is still aligned in the Insert and the O-Rings
remain in position.
LED Strip
Jet Plate
Curvature
Marking