- 8 -
STEP 1
CHANGING THE ACCENT
It is possible to exchange the Accent on any Magnitude CPU Water
Block for an Accent with a different color or material finish. A
translucent D-RGB Accent can also be used to add lighting to any
version of Magnitude with an opaque Top.
STEP 1
Unscrew the four Screws from the bottom of the CPU Water Block
in an anticlockwise direction, remove the Frame, Coldplate and LED
Strip if installed. A 2.5mm Allen (hex) key is supplied for this. If an
LED Strip is already installed and you do not wish to change where
the cable exits then it does not need to be removed from the Frame.
STEP 3
STEP 3
Put the desired Coldplate in place paying attention to the orientation,
failure to do so will prevent installation of the Screws. The curvature
marking should be on the same side as the curvature marking of the
Frame. Lastly screw in the four Screws, do not use excessive force!
Screw
Frame
Screw
Curvature Marking
Curvature Marking
To Next Page
Loading...
