EasyManuals Logo

ekwb EK-Quantum Kinetic TBE DDC PWM Series User Manual

ekwb EK-Quantum Kinetic TBE DDC PWM Series
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
- 9 -
EK-Quantum Kinetic TBE 160 DDC combo unit:
The internal tube, which is enclosed in a mounting Kit, can
be used for fluid intake into the reservoir. Make sure that
the sealing gasket on the inner tube is placed correctly.
EK-Quantum Kinetic TBE 120 DDC combo unit:
In the case of 120 Version, please follow these steps:
- Unscrew the reservoir and take off the pre-installed
Anticyclone
-
Remove the top part of the reservoir and attach the
internal tube on one of the three (3) G1/4 holes (make sure
that sealing gasket on the internal tube is placed correctly)
- Secure the top to the reservoir and make sure that all
gaskets are set appropriately.
CAUTION
Using the Internal tube and pre-installed Anticyclone at
the same time is strongly not recommended! This can
damage the Anticyclone.
IMPORTANT
Fittings must be placed on the Top port before installing
the Internal tube. In other case, you can damage the Top!

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ekwb EK-Quantum Kinetic TBE DDC PWM Series and is the answer not in the manual?

ekwb EK-Quantum Kinetic TBE DDC PWM Series Specifications

General IconGeneral
Brandekwb
ModelEK-Quantum Kinetic TBE DDC PWM Series
CategoryComputer Hardware
LanguageEnglish

Related product manuals