ekwb Velocity-AMD - Page 14

- 14 -
CONNECTING THE RGB LED STRIP
STEP 1
Plug the 4-pin connector from the water block and fan’s RGB LED light
to the RGB HEADER on the motherboard. The LED will work if the pin
layout on the header is as follows: +12V G R B.
Please ensure that the arrow indicated on the connector
is plugged into the +12V line as indicated on your
motherboard.
Failure to do so will damage your motherboard or LED strip.
CONNECTING THE DRGB LED STRIP
STEP 1
Plug the 4-pin connector from the water block’s D-RGB LED light to
the DRGB HEADER on the motherboard. The LED will work if the pin
layout on the header is as follows: +5V, Digital, empty, Ground.
Please ensure that the arrow indicated on the connector is
plugged into the +5V line as indicated on your motherboard.
If you put LED Diode to the 12V RGB HEADER you can
damage the LEDs.
Failure to do so will damage your motherboard or LED strip.
D-RGB HEADER
RGB HEADER
STEP 1
D-RGB HEADER
RGB HEADER
STEP 1