SMARTASH 13 D-044 Rev 008
www.elastec.com
REQUIRED ACCESSORIES
REQUIRED ACCESSORIES
1. Three-wire, outdoor electrical extension cord
Under 25 feet (15 meters) = No lighter than 18 gauge
Over 50 feet (30 meters) = No lighter than 16 gauge
2. Safety glasses
3. Gloves (appropriate for hot surfaces)
4. Several sections of newspaper or cardboard
5. Matches or lighter
PREPARING TO BURN
1. Select a site at least 10 feet / 3 meters from buildings, hedges and trees.
Place SmartAsh on bare ground, gravel or concrete. Do not burn on asphalt
surfaces, lawn or ground with dry vegetation, as drum bottom becomes very
hot.
2. Position SmartAsh so that cart, air supply and operator are upwind and
drum is downwind.
3. Connect SmartAsh plug to extension cord and cord to grounded electrical
outlet. Depress the reset button on Saf-Start plug.
WARNING: To prevent accidental interruption of burning, install cord lock and
arrange slack in cord beneath plug-in.
NOTE: If there is a power interruption during the operation of your SmartAsh
unit, follow the steps below for restart:
Turn toggle switch to OFF position.
Move air control latch to START position.
Allow unit to cool for 10 minutes.
Reset Saf-Start.
Remove lid and repeat ignition procedure as normal.
WARNING: Failure to observe these cautions may result in rapid internal
combustion when air returns. This could cause damage to the drum lid or lip
and could cause possible personal injury.
To Next Page