SMARTASH 6 D-044 Rev 008
www.elastec.com
SAFETY PRECAUTIONS
To avoid accident or injury, please follow these safety precautions:
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the product.
3. This product must be disconnected from the power source when there is a
chance that water may come in contact with the electrical connection.
4. Ensure that the SmartAsh is on stable ground and in no danger of falling
or tipping.
5. Wear safety glasses and gloves at all times during operation.
6. The combustion system must stand free and clear of surrounding
buildings, vegetation or other combustible material. Please allow 10 feet (3
meters) of space. Care should be taken to ensure that no flammable items
are above the emission screen.
7. Never touch the combustion chamber (steel drum) or lid while incinerating
refuse.
8. Refer servicing to qualified personnel under the following conditions:
The power supply cord is frayed or damaged.
Liquid has been in contact with the electrical system.
The product has been damaged and exhibits a distinct change in
performance.
9. Do not operate this product in the vicinity of flammable gases.
10. Aerosol or pressurized cans cannot be incinerated in this system.
11. If the operator is unsure if certain items can be safely incinerated, consult
the manufacturer for details and instructions. Please refer to Page 4 for
contact information.
12. Use only outdoor three-wire electric cord connected to a grounded outlet.
Do not run cord over wet ground. Keep cord away from drum. If cord
becomes damaged, replace immediately.
13. Ensure that no aerosol cans are in the load.
14. Ensure that clothing does not come into contact with drum or lid during
burning.
To Next Page