www.elationlighting.com 8
SAFETY INSTRUCTIONS AND GUIDELINES
DO NOT TOUCH the fixture housing during operation. Turn OFF the power and allow
approximately 15 minutes for the fixture to cool down before serving.
DO NOT shake fixture, avoid brute force when installing and/or operating fixture.
DO NOT operate fixture if the power cord has become frayed, crimped and/or damaged.
If power cord is damaged, replace it immediately with a new one of similar power rating.
DO NOT block any air ventilation slots. All fan and air inlets must remain clean and
never blocked. Allow approx. 6” (15cm) between fixture and other devices or a wall for
proper cooling.
When installing fixture in a suspended environment, always use mounting hardware that
is no less than M10 x 25 mm, and always install fixture with an appropriately rated
safety cable.
Always disconnect fixture from main power source before performing any type of
service and/or cleaning procedure. Only handle the power cord by the plug end, never
pull out the plug by tugging the wire portion of the cord.
During the initial operation of this fixture, a light smoke or smell may emit from the
interior of the fixture. This is a normal process and is caused by excess paint in the
interior of the casing burning off from the heat associated with the lamp and will
decrease gradually over time.
Consistent operational breaks will ensure the fixture will function properly for many
years to come.
ONLY use the original packaging and materials to transport fixture in for service.
The average LED Life (hours) may vary depending on several factors including but not
limited to: Environmental Conditions, Power/Voltage, Usage Patterns (On-Off Cycling),
Control and Dimming.
To Next Page
Loading...
