!
MENU AND SETUP FUNCTIONS
REMOVE FIXTURE PROFILE
Use this to remove individual profiles from memory. When you enter this menu the message
“Select profile to remove, press enter” will appear on the top line of the display. The first
profile found in memory will appear on the bottom line, use data wheel 1 to select from the list
of saved profiles. Press “enter” to remove any selected profile.
UPDATE SOFTWARE
This lets you to update the software inside Show Designer 2CF from a software update file on a
compact flash card. If a CF card is inserted, the Show Designer 2CF will search the card for the
proper file and then install it. The message “RECEIVING NEW PROGRAM” will appear as the
new software file is installed. Upon completion, the system will reboot. Read the section at the
end of this manual on using the compact flash for more information.
LOCK/UNLOCK MEMORY
This is one of the hidden menu items that can only be selected while holding the “add” switch
when cycling through the menu selections. This feature allows you to lock the memory to
prevent someone from changing or erasing anything that has been recorded. The message
“MEMORY LOCKED, CAN’T RECORD” will appear if the memory is locked and anyone presses
the record switch. All other menu items will also be locked out in order to protect the memory.
To lock or unlock the memory from this menu, use data wheel #1 to select the desired state,
then press “enter”.
ERASE ALL MEMORY
This is another one of the hidden menu items that can only be selected while holding the “add”
switch when cycling through the menu selections. This menu item allows you to clear the
entire memory of the Show Designer 2CF. This erases the scene, preset, chase and show data as
well as the system parameters such as fixture assignments. The message “ARE YOU SURE?
HOLD “YES” 5 SEC” will appear in the display. Press and hold “yes” until the system reboots or
press “no” to exit.
To Next Page
Loading...
