15
Using your dishwasher
DW60CR MODELS
9
Turn the Programme dial to “Reset”.
10
Press the Power button to turn the dishwasher off.
The “End” light will go out.
11
Turn off the water supply.
12
Open the door and leave it slightly ajar.
13
Wait for a few minutes, then remove the dishes once they are cool enough to touch.
If you want to change the programme
A wash programme can be changed if it has only been running for a short time. The detergent
dispenser may need to be refilled.
To change a programme
1
Turn the programme dial to “Reset”.
2
Select a new wash programme.
If you don’t want to run a programme at all
To cancel a programme
1
Turn the programme dial to “Reset”.
The “End” light will stop flashing and be steadily lit.
The wash programme has now been cancelled, but the dishwasher may continue to run for
some time after this – if it has water in it, it will automatically drain.
2
Wait until the dishwasher has completely stopped.
3
Check that all the water has been drained.
4
You may now press the Power button to turn the dishwasher off.
To Next Page
Loading...
