What to do if my Elba Ventilation Hood and light aren't working?
If your Elba Ventilation Hood and light aren't functioning, first, check if the plug is well connected and the power is switched on. If the problem persists, the power cord may be damaged, and you should contact technicians for repair.
Why is my Elba EH-E9122ST(BK) suction weak?
Weak suction in your Elba Ventilation Hood can occur if the distance between the hood and the stove is too far. Lower the hood installation height, but stay within the safety guidelines. Another cause could be strong convection due to too much ventilation. Try shutting off some windows or doors.
What to do if my Elba Ventilation Hood is vibrating?
If your Elba Ventilation Hood is vibrating, the screws might be loose. Try tightening them.
What to do if the motor of my Elba EH-E9122ST(BK) Ventilation Hood works but the light doesn't?
If the motor of your Elba Ventilation Hood is working but the light isn't, the light bulb is likely damaged. Replace it with a new 2W light bulb.
What to do if the light works but the motor of my Elba Ventilation Hood doesn't?
If the light works but the motor of your Elba Ventilation Hood isn't functioning, the bearing may be damaged. Contact technicians to repair it. Also, the internal wires or motor capacitor may be burnt out.
Controls standby mode and activates a three-minute delay timer for shut-off.
Button to operate the cooker hood at its lowest fan speed setting.
Button to operate the cooker hood at its highest fan speed setting.
Activates maximum fan speed for one minute before reverting to high speed.
Button to switch the LED lamp on or off.
Detailed steps for removing and cleaning the interior components, including the glass panel and filter.
General| Width | 90 cm |
|---|---|
| Number of Speed Settings | 3 |
| Color | Black |
| Number of Motors | 1 |
| Voltage | 220-240V |
| Frequency | 50/60Hz |
| Lighting | LED |
| Filter Type | Aluminum |
| Material | Stainless Steel |
To Next Page
