Elba EH-E9122ST(BK) - Replacing the Light Bulb; Troubleshooting

6
 Turn the locknut in clockwise direction to take out the impeller.
REPLACING THE LIGHT BULB
 Disconnect the power supply, push the panel upward
with both hand to take down the panel slowly
 Slightly insert the screwdriver in the edge of the lamp
and pry downward to take out the LED lamp (2W).
 Disconnect the connecting cable of LED lamp (2W) and
replace a new LED lamp unit (2W). Connect the power
supply to ensure LED lamp (2W) is function.
※ The LED lamp bulb is shall not be greater than 2W.
TROUBLESHOOTING
Malfunctions
Possible Root Cause
Checking
Weak Suction
The distance is too far between
the hood and stove
Lower down the Hood installation
height but within the safety guideline
Strong convection due to too
much ventilation
Shut off some of the windows or
doors
Hood and light not
function
The power supply not connected
Check the plug is well connected and
power is switched on
Power cord is damaged
Contact technicians for repair
Motor function but light
not works
Light bulb is damaged
Replace a new light bulb ( 2W)
Light works but motor
not function
The bearing may be damaged
Contact technicians to repair
The internal wires or motor
capacitor may be burnout
Vibration on the hood
The screw is loosen
Tighten the screws
The hood is noisy
Exhaust pipe surface is distorted
Contact technicians to reinstall the
exhaust pipe