Installation
Selection of installation equipment
1. Cut out the work surface according to the sizes shown in the drawing. For the purpose
of installation and use, a minimum of 50mm space shall be preserved around the hole.
Be sure that the thickness of the work surface is at least 30mm. Please select
heat-resistant work surface material to avoid larger deformation caused by the heat
radiation from the appliance. Installation as shown below:
Under any circumstances, make sure the hob is well ventilated and the air inlet and outlet
are not blocked. Ensure the hob is in good working condition as shown above.
Note: The safety distance between the hotplate and the cupboard above the
hotplate should be at least 760mm.
To Next Page
Loading...
