Using your Induction Hob
To start cooking
After power on, the buzzer beeps once. All the indicators light up for 1 second then go out.
Indicating the induction hob has entered the state of standby mode.
1. Touch the ON/OFF control. All the indicators show “-“.
2. Place a suitable pan on the cooking zone that you wish to use. Make sure the bottom of
the pan and the surface of the cooking zone are clean and dry.
3. Touch the heating zone selection control.
4. Select a heat setting by sliding the control panel. If you don’t choose a heat setting
within 1 minute, the induction hob will automatically switch off. You will need to start
again at step 1. You can modify the heat setting at any time during cooking. By slide to
left or right direction, the value will adjust up or down.
To Next Page
Loading...
