Before locating the fixing brackets
The unit should be placed on a stable, smooth surface (use the packaging). Do not apply
force onto the controls protruding from the hob. Fix the hob on the work surface by screw
four brackets on the bottom of hob (see picture) after installation. Adjust the bracket position
to suit for different work surface’s thickness.
Connecting the hob to the mains power supply
The power supply should be connected in compliance with the relevant standard, or a
single-pole circuit breaker. The method of connection is shown below.
1. If the cable is damaged or needs replacing, this should be done by an authorized
technician using the proper tools, so as to avoid any accidents.
2. If the appliance is being connected directly to the mains supply, an omnipolar circuit
breaker must be installed with a minimum gap of 3mm between the contacts.
3. The installer must ensure that the correct electrical connection has been made and it
complies with the safety regulations.
4. The cable must not be bent or compressed and shall be checked regularly.
To Next Page
Loading...
