R
8
2.4 AFTER THE TEST
Decrease pressure to zero by turning handle fully anti-clockwise.
2.5 CLEAN THE DOLLY
Cleaning the dolly produces unpleasant fumes - ensure that the work area is extremely well
ventilated.
Do not inhale the fumes.
HOT! Exposed very hot surfaces. Use great care when handling or placing the tongs. Allow to
cool before storing.
1. Plug the Pipemaster heating tongs into the mains supply and leave to warm up for 5 minutes.
2. Heat the dolly with the tongs for 3 to 5 minutes. This will soften the adhesive.
3. Using a sharp blade, remove the adhesive/coating from the test surface of the dolly.
4. Drop the dolly into water or allow to cool naturally. Do not put the Pipemaster heating tongs into water.
5. To remove any remaining adhesive, rub the dry, cool dolly with fine sandpaper or similar.
6. Use the dolly tool to clear any adhesive from the dolly centre.
7. Wipe the dolly test surface with a solvent to remove oil and grease.
To Next Page
Loading...
