9-12
HOW TO USE YOUR MOTORHOME’S EQUIPMENT
WHALE WATER HEATER
The Whale 13L Gas and Electric Storage water
heaters.
• 13L capacity hot water tank.
•Twin electric element
• 1200W - Fast heat up (5.2A)
• 600W - Low current draw (2.6A)
• No flue cover required
• Fully insulated
• Flue adaptor plate available AK1203
Rapid and Efficient Heat
The unique twin element (patent pending) allows
a choice of settings. A low setting of 600W and a
high setting of 1200W gives the option of low
power consumption for faster water heat up.
Versatile Control
The Whale 13L Water Heater has simple to use
on/off switch control functions to provide 5
running options.
• Gas Only
• Electric Low Setting
• Electric High Setting
• Gas and Electric Low
• Gas and Electric High
IMPORTANT
In the interest of safety, replacement parts
for an appliance shall conform to the
appliance manufacturer’s specifications and
should be fitted by him or an authorised
agent.
Fault Finding
No. of Fault Remedy
Flashes
1 No flame detected Check gas supply.
2Overheat Check there is water in the appliance. We recommend you
wait at least 5 to 10 minutes to allow the heater to cool
before clearing lockout as described below.
3Low/high supply voltage Ensure voltage is above 10V at the heater and below 15V.
5 Other/internal fault Attempt to clear lockout as shown below. If this fails
contact: Heater Support: 0845 217 2933.
To clear any lockout switch off and back on within 2.5 seconds.
To Next Page
Loading...
