10-2
SECURITY
Enhanced Features Arming The System In
“At Home” Mode
In the ‘at home’ mode, any sensor that is
programmed to be isolated, such as the PIR
sensor will not trigger the alarm. Other sensors
will trigger the siren. Arm as normal followed by a
second press on the arm/disarm button within 2
seconds. Normal “on” tone followed by “at
home” tone indicating isolation is active. Settling
time of 15 seconds before responding to triggers.
Armed in the isolation mode will be indicated by
a double flash intermittently of the LED. The “at
home” sensors will be isolated; other sensors will
trigger the siren for 30 seconds.
Arming the System in Test Or Buzz Mode
In the buzz mode the siren will sound a short
tone when a sensor is triggered instead of
sounding for 30 seconds. It is advisable to test all
the sensors
To Next Page
Loading...
