5-5
ARRIVING ON SITE
Extensive function declaration
(1) SLOPE TOO STEEP In this position the caravan cannot be levelled (the
surface is not even enough) If necessary switch over
to manual mode.
(2) BATTERY LOW VOLTAGE The battery is empty of the voltage is too low to be
able to work safely.
(3) WITHDRAW FRONT WHEEL The caravan is too high at the front, withdrawn the
front wheel and the LED will go out.
(4) JACKS NOT (fully) One or more jacks are extended or not fully
retracted.
RETRACTED
(9) MANUAL MODE Indicates that the caravan can now be brought to the
correct level manually.
(14) LEVEL (zero point) Indicates that the caravan can now be brought to the
correct level.
(15) BATTERY 9V VOLTAGE The battery voltage of the remote control is too low
(only present on the remote control)
(16) E&P LOGO Indicates that the levelsystem is switched on.
(only present on the remote control)
BUTTONS
(5) ON/OFF Switches the levelsystem on or off.
(6) MANUAL MODE Switches the levelsystem into manual mode for
levelling the caravan.
(7) AUTOMATIC MODE Switches the levelsystem into automatic mode for
levelling the caravan.
(8) RETRACT ALL JACKS Automatically retracts all jacks.
(10) LEFT SIDE Controls retracting and extending the left jacks.
(11) REAR SIDE Controls retracting and extending the rear jacks.
(12) FRONT SIDE Controls retracting and extending the front jacks.
(13) RIGHT SIDE Controls retracting and extending the right jacks.
AUTO
To Next Page
Loading...
