Eldes EWD3 - Temperature Sensor; Shock Sensor

11EN
EWD3 WIRELESS MAGNETIC DOOR CONTACT/SHOCK SENSOR/FLOOD SENSOR-READY
Supported zone mode combinaions and batery lifeime:
ZONE 1 ZONE 2
Magneic door contact
Shock sensor (up to 3 years)
Flood sensor (up to 4 years)
NO/NC sensor (up to 5 years)
EOL sensor (up to 2 years)
Tapparella (up to 3 years)
N/A (up to 5 years)
NO/NC sensor
Shock sensor (up to 3 years)
N/A (up to 5 years)
EOL sensor
Shock sensor (up to 2 years)
N/A (up to 2 years)
The batery operaion ime may vary under diferent coniguraion and condiions.
In case of tamper violaion, the alarm is caused regardless of system being armed or disarmed. There are 2 ways to detect tamper violaion on EWD3:
• By tamper switch. EWD3 comes equipped with a tamper switch intended for enclosure supervision. Once the enclosure of EWD3 is tampered, the
tamper switch will become triggered. By default, this acion will be followed by alarm, resuling in SMS text message delivery and/or phone call to the
user. The SMS text message contains the violated tamper name.
• By wireless connecion loss. The wireless connecion loss between EWD3 and ELDES alarm system leads to alarm. The system ideniies this event
as a tamper violaion and sends alarm by SMS text message and phone call to the user (-s) by default. The SMS text message contains the wireless
device model, wireless ID code and tamper name. The user will also be noiied by SMS text message as soon as the wireless signal is restored.
The tamper will not operate if both wireless zones are disabled.
For more details on EWD3 zone and tamper coniguraion, please refer to ELDES coniguraion sotware’s documentaion.
4. TEMPERATURE SENSOR
The device comes equipped with a temperature sensor allowing to monitor the temperature of the area surrounding EWD3 device. When using the device
paired with the alarm system, you may set the MIN and MAX temperature thresholds ranging from -20°C to +55°C (-4... +131°F) resuling in a noiicaion
delivery to the listed user and/or PGM output acion (turn ON/OFF; only on ESIM364 and ESIM384) once exceeded.
5. SHOCK SENSOR
EWD3 contains a built-in shock sensor (accelerometer) that detects the surface vibraions, such as drilling, knocking, hammering, of the locaion where the
device is installed. This feature allows to receive the alarm noiicaion in accordance with one of the selected sensiivity levels:
SENSITIVITY LEVEL DETECTION PROXIMITY
Low ~0,5m (~1.6t)
Medium ~1m (~3.3t)
High <2m (<~6.6t)
Custom for advanced users