Eldes EWKB4 - SAFETY INSTRUCTIONS; WARRANTY PROCEDURES

WIRELESS LED KEYPAD EWKB4
18
EN
EWKB4 device and uninterrupted service, it is the responsi-
bility of the User to make sure that: (I) the product is properly
installed, and (II) there is constant electrical supply (low batery
must be replaced in ime).
If you experience diiculty during the installaion or subse-
quent use of the system, you may contact “ELDES, UAB” dis-
tributor or dealer in your country/region. For more informaion
see eldesalarms.com
SAFETY INSTRUCTIONS
Please read and follow these safety guidelines in order to
maintain safety of operators and people around:
• DO NOT use the device where it can cause potenial danger
and interfere with other devices – such as medical devices.
• DO NOT use the device in hazardous environment.
• DO NOT expose the device to high humidity, chemical
environment or mechanical impact.
• DO NOT atempt to repair the device yourself – any repairs
must be carried out by fully qualiied personnel only.
• EWKB4 can be powered by 3 bateries of 1,5V Lithium AA
type FR6 (IEC) / 15LF (ANSI/NEDA) or 1,5V Alkaline AA type
LR6 (IEC) / 15A (ANSI/NEDA). When insering the bateries
into the batery slots, mind the polarity terminals!
• To switch the device of, remove all bateries. A blown fuse
cannot be replaced by the user. The replacement fuse has to
be of the kind indicated by the manufacturer (fuse F1, F2, F3
model – MINISMDC050F 0.5A).
• The device is not meant for outdoor use, i.e. you should use
it inside a building. Protect the device against cold, heat and
keep away from direct sunlight while in storage or operaion.
WARRANTY PROCEDURES
Warranty and out of warranty service should be obtained by
contacing the system integrator/dealer/retailer/e-tailer or
distributor where the customer purchased the product. When
requesing for service, the proof of purchase and the product
serial number must be provided. The return of the defecive
product should be strictly through the original route of purchase,
and the customers shall pack the product appropriately to prevent
the returned product from sufering in the transportaion.