Eldes EWKB5 - 4. Battery; Battery Replacement

7EN
ELDES WIRELESS TOUCHPAD EWKB5
4. BATTERY
EWKB5 does NOT feature a built-in batery charging unit, therefore only
1,5V Lithium AA type (non-rechargeable) bateries can be used. The
bateries are used only in case of a main power failure!
BATTERY REPLACEMENT
1. Acivate Service mode by accessing the seings menu (Master code required) or
using alternaive methods, such as SMS text message.
2. Open EWKB5 enclosure.
3. Remove the old bateries from the batery slots.
4. Insert the new bateries based on the batery slot posiive/negaive terminals
indicated on the batery slots of EWKB5.
+
+
+
+
+
+
-
-
-
-
-
-
• Only 1,5V Lithium AA type FR6 (IEC) / 15LF (ANSI/NEDA) bateries can
be used. Install only new, high quality and unexpired bateries. Do not
mix the old bateries with the new ones.
• All bateries must be removed if the device is not in use.
• In order to avoid ire or explosion hazards, the system must be used only
with approved batery. Special care must be taken when connecing
posiive and negaive batery terminals. Dispose old bateries only into
special collecion sites. Do not charge, disassemble, heat or incinerate
old bateries.
• The batery status can be monitored in real-ime on EWKB5 screen or
by using ELDES coniguraion sotware.
• The system sends an SMS text message to the listed user phone
number as soon as the batery level runs below 5%.