ELECRAFT K4 - Page 109

108
Screen Cap File
Specifies the base filename for screen capture files. Tapping <Fn>
<SCRN CAP> captures both the LCD and external monitor screens to
separate files with this base name, but different suffixes.
Serial RS232: Auto Info
Sets the Auto-Info mode for this port. The default is NOR (no auto-info).
In the AUTO1 setting, the K4 will emit "IF" command responses on certain
control changes including VFOs, mode, and RIT. For further details on
auto-info ("AI" command) and the "IF" command, refer to the K4
Programmer's Reference.
Serial RS232: Baud Rate
Specifies the baud rate for this port (4800, 9600, 19200, 38400, 57600,
or 115200 baud).
Serial RS232: DTR
Specifies the function of the DTR pin for this port (OFF, PTT, KEY, FSK).
Serial RS232: RTS
Specifies the function of the RTS pin for this port (OFF, PTT, KEY).
Serial USB-PC1: Auto Info
Sets the Auto-Info mode for this port. The default is NOR (no auto-info).
In the AUTO1 setting, the K4 will emit "IF" command responses on certain
control changes including VFOs, mode, and RIT. For further details on
auto-info ("AI" command) and the "IF" command, refer to the K4
Programmer's Reference.
Serial USB-PC1: Baud Rate
Specifies the baud rate for this port (4800, 9600, 19200, 38400, 57600, or
115200 baud).