41
Frequency Memory Controls
Tapping [RCL] or [STORE] brings up the frequency memory selector,
which provides 200 general-purpose memories. There are also 4 Quick
Memories per band, accessed by tapping [M1]-[M4] after tapping
[RCL] or [STORE].
For details see FREQUENCY MEMORIES.
Receive Audio Record/Playback
The K4 can record and play received audio. Both main and sub audio
are recorded and played if the sub receiver was on during record. To
bring up receive audio record/play controls, hold [AF REC] or [AF
PLAY]. See Recording and Playing Receive Audio.
VFO B and B SET
The VFO B knob (upper right-hand corner of the front panel) sets the
frequency of VFO B.
Just below the VFO B knob is [B SET], the VFO B SET switch. When [B
SET] is tapped, the B SET icon turns on, just above the RIT/XIT box at
the upper middle of the LCD. B SET allows you to directly set up VFO B
and the sub receiver. (Tap [B SET] or the icon again to exit.)
For example, the tuning rate for VFO B can be set by tapping [B SET],
then tapping [RATE] or holding [KHZ]. VFO B's frequency can be
directly set by tapping [B SET], then [FREQ ENT]. B SET can also be
used to set up the preamp, attenuator, filter bandwidths, and other
VFO B/sub settings.
Also see RECEIVER SETTINGS, BAND SELECTION, and DUAL RECEIVE.
To Next Page
Loading...
