77
Tap-to-QSY
Briefly tapping a signal on the display moves the VFO cursor to its
frequency. In TRACK mode, this also shifts the panadapter position so
that the cursor is re-centered at the VFO cursor.
If you tap on a signal and keep your finger on the LCD, the mini-pan is
displayed, and you can then fine-tune the signal so that it lines up with
the cursor. The mini-pan will be turned off after you lift your finger.
Tap-to-QSY can be disabled for either the A or B panadapter by locking
the A or B VFO.
DUAL RECEIVE
All K4 models have dual-receive capability, which allows the main and
sub receivers to be used simultaneously, even on two different bands.
In all cases, the main receiver is associated with VFO A, and the sub
with VFO B.
Note: To enable independent band selection for VFO B, set MENU:VFO
B Different Band to YES.
Dual receive can be used with SPLIT, as well as with transverter bands.
Dual receive is turned on by tapping the [SUB] switch (to the right of
the VFO A knob).
Tap [B SET] to directly change settings for the sub receiver/VFO B,
such as preamp, attenuator, NB, NR, or filtering. B SET mode can also
be entered by tapping <SUB RX>.
When the internal speaker is being used, or when using only one
external speaker, main and sub receiver audio is mixed together
To Next Page
Loading...
