ELECRAFT K4 - Fn

43
III. OPERATING INSTRUCTIONS
This section emphasizes setup and operating procedures. You may
wish to review the Key to Text Styles.
** Indicates a feature that is still in development.
PRIMARY FUNCTIONS
Before putting your K4 on the air, you should become familiar with the
primary function buttons located at the lower edge of the LCD screen.
These functions, used for basic setup of transmit, receive, and
panadapter operation, are described below.
New HF operators will find the defaults to be satisfactory in most
cases.
Also see Introduction to the Elecraft K4.
MENU
Tapping <MENU> brings up a list of settings that are infrequently
changed. The entries are in alphanumeric order.
Using VFO A or the up/down arrows, scroll to highlight the desired
menu entry. Tap the lock symbol (if present) to unlock it, then tap the
parameter field. Use VFO A or the up/down arrow buttons to adjust
the value. In some cases a small keypad icon will appear, indicating
that the numeric keypad switches above the VFO may be used to
enter the highlighted parameter.
Tap <NORM> to use the default value. For a full list of menu entries,
see IV. MENU LISTING.
Programmable function switches [PF1]-[PF4] can be assigned to often-
used menu entries. See PF1-PF4.