USB, and Ethernet connections for this purpose. Computer applications can
configure and operate all aspects of the transceiver, and in some cases can
read low-bandwidth dB/bin data for use in spectral displays. For setup
instructions, refer to the applicable software application manuals.
SOFTWARE DEVELOPERS: The K4 implements a large superset of the K3/K3S
host command set. For details, please refer to the K4 Programmer's Reference.
Remote Front Panel Emulation
Overview
Remote front panel emulation is typically used to access a server K4 from
another location at your home or property, or one at a location with better
antennas or propagation. This remote server radio may be your own, or one
anywhere else in the world that another operator has allowed you to use (by
prearrangement). A client device is used to emulate the front panel of the
server radio, as if you were at the server location. Instead, you might be at
your home, in a hotel room, in an RV – or virtually anywhere network
connectivity is available.
The K4's implementation of remote makes such operation simple, seamless,
and immersive. You'll have complete control over the distant station. No
special interface devices are needed – just a router at each end. There is also
no need to change your K4's cabling for computer logging, data modes, etc.
The client seamlessly routes commands, data, and audio from these to the
server as required.
Several types of client devices are supported: (1) another K4, (2) our K4/0**
compact front-panel unit, or (3) our VK4 Windows** application, or (4) a third-
party iOS** application. Other apps and platforms may be available in the
future.
A K4 used as a client can be disconnected from the server, when desired, to
use the radio with local antennas. The K4/0 is a control-only device (no RF),
87
To Next Page
Loading...
