EN-3
BASIC OPERATION OF THE HYENA ASSIST SYSTEM
See the rst pages of this guide for the Figures referenced below.
1. Turning the e-bike system on/off (Figure A)
• Single press the power button to switch on the system.
• Press the power button longer than 2 seconds to switch off the system.
• Riding with the assist system turned off is like riding a normal, non-electric
powered bicycle.
• Always switch off the e-bike system when parking.
2. Selecting an assist level (Figure B)
• Once the assist system is switched on, the system will default to Level 0.
Select the desired assist level using the UP (+) and DOWN (-) buttons.
• Select between four levels: Level 0 (0%, no assist), Level 1 (Max. 140%),
Level 2 (Max. 250%) to Level 3 (Max. 390%, maximum assist).
The number of illuminated red LEDs show the selected assist level: none
(Level 0) to the maximum of three (Level 3).
• When learning to ride an e-bike, start at the lowest assist level and gradually
increase levels.
• The maximum range on one battery charge will decrease with higher assist
levels.
• The e-bike drive output only provides support up to the maximum speed
permitted by local regulation (25 kmh/20 mph). As soon as you have reached
this speed limit, the assist system will suspend the riding support and
automatically reactivates when your speed is below the speed limit.
• The assist modes affect how much support the assist system delivers based
on your pedaling input.
• If your e-bike is equipped with gears, change gears appropriately to get the
most use out of your battery.
To Next Page
Loading...
