EN-5
5. Charging the battery (Figure D)
Your e-bike is equipped with a charging socket on the bike to charge the integrated
battery. Charge the battery indoors or in a garage at room temperature, to avoid
exposure to rain or wind. Do not use the charger outdoors or in environments with
high humidity.
• To charge the battery, open the cover of the charging socket on the e-bike.
• Connect the charging plug of the supplied charger with the charging socket
on the battery.
• Plug the AC-plug of the charger into an outlet (100V to 240V).
►
The LED on the charger will illuminate red while charging.
► While charging, the charge level indicator on the console will show the
charge level of the battery. Each illuminated green LED on the console
represents approximately 20% capacity.
► The battery is fully charged when the indicator on the charger turns green
and all green LEDs on the charge level indicator on the console illuminate.
Note. The e-bike system will power off after reaching full charge (within about six
minutes).
• After charging, disconnect the AC-plug from the outlet and the charging plug
from the battery.
6. Turning on/off the lights (if equipped, Figure E)
• Some e-bikes are equipped with a front and rear light powered by the assist
system.
• With the system turned on, press and hold the UP (+) button for two seconds
to turn the lights on or off.
Notes.
• At 4% charge, the riding support will stop. The remaining charge capacity is
reserved to power the lights for up to two hours.
• If your battery is empty, the lighting on your e-bike may not work until the battery
is recharged.
To Next Page
Loading...
