18 Eco 3 & 4 Scooter Owner’s Manual & Service Record
Servicing and Maintenance
1. This vehicle is designed for minimum maintenance. However it is recommended that your vehicle is
serviced at least once a year, by an approved Electric Mobility Dealer. If the vehicle is used constantly we
recommend a twice yearly maintenance.
2. Ensure the engineer stamps the Service Log (page 23) on completion for all servicing carried out on
this vehicle. Keep all receipts for servicing and repairs with this handbook. This may add value when selling
the vehicle.
3. When the vehicle is due for its annual service make sure you report any concerns you have,
preferably when you book the service (See points to look out for below).
4. On completion of the service, Always test the vehicle before the engineer leaves and make sure you
are satisfied with the work carried out.
Points to look out for:
• Are there any strange noises from the wheels or does the frame creak when going over rough ground?
• Is the battery charged up corr
ectly – is the “full” charge green light on after charging?
• Is the steering tight or is it loose when turning? Is there any play in the steering?
• Has anything come loose?
• Does the vehicle perform as well as it did when it was new?
• Are there noises or rattles that were not there before?
• Are there any signs of damage or cracking?
Engineer’s Checklist for Eco 3 and 4 Models
Important Note for the Engineer
Enquire if the customer is satisfied with the pr
oduct. Please r
eport all points good or bad dir
ectly to:
Electric Mobility 01460 258100 If you have any comments please include them.
Obtain all comments from the customer on the condition and serviceability of the scooter and then complete
an Initial diagnostic road test. Record all defects to be corrected. Now check, test and complete the following:
• Wheel bearings wear and lubricate
• Wheel alignment and tracking
• Speed dial works correctly
• Wear or damage to tyres or wheels
• Bodywork fixtur
es for damage, or cracking
• Throttle play and adjustment
• Battery box contacts & signs of corrosion
• Check all cables for damage, abrasion, corrosion
and that screening is intact. Replace as necessary
• Steering bearing (adjust as required)
• T
iller adjustment - functioning, wear and damage
• Tiller lock – functioning, wear and damage
• Seat mounting for wear or damage
• Revolving seat mechanism locates correctly and
spring lever engages. Lubricate as necessary
.
• Handlebar alignment
• Motor brush wear
• Motor speed check
• Electr
omagnetic brake operation
• Freewheel operation
• Frame for damage or cracks
•
Fr
ont and rear chassis attachment points for
corrosion, wear or damage
• General check for corrosion, repair or
protect as necessary
• All operational controls work correctly
• Battery condition and charger operation
• T
ighten all nuts & bolts
Correct all defects found and determine
if the vehicle is roadworthy.
• Final road test
• Clean vehicle
• Customer road test
To Next Page
Loading...
