Electric Mobility Liteway Balance - Transferring in and out of Your Scooter

11
• Rotate the knurled knob
c
lockwise and ensure that it is
tight and the retaining serrations
are fully engaged
• Adjust the tiller to suit your
driving position, ensuring the
t
iller is firmly locked in place
before driving off.
Warning! Before driving, always check that the tiller is securely in the upright position. Safe steering may
be impossible if you do not !
Transferring In And Out Of The Scooter
If you feel at all uncertain about getting in or out of the scooter seek assistance.
Transferring into the Scooter from the Front
Before getting in:
• Make sure that the scooter is on a level surface, and it is not in Freewheel mode.
• Make sure the brakes are engaged - try to push the scooter a little to verify that the brakes are working.
• Ensure that the inition key is turned off. (The red LED / lamp on the dashboard will not be lit or flashing)
• Ensure that the handlebar / tiller adjustment is fully tightened and that any accessories such as the
shopping basket are properly fitted
• Ensure that the battery is fully located in its mounting position.
• The seat should be facing forwards.
• Adjust the handlebars / tiller so that the front wheel is facing forwards.
You are now ready to get in:
• Approach the chair from the side and step over the centre part of the scooter with one foot. You should
now be straddling the scooter facing forwards and with the seat behind you. With your back to the seat,
you can steady yourself using the armrests and then lower yourself gently into the seat.
• Lift each of your feet onto the footrest platform.
Getting out of the Scooter:
• Before getting out of the scooter, be sure that it is on a level surface and the power key is switched to the
off position. - If you feel uncertain about getting out, seek assistance. Move the handlebars so that the front
wheel is facing directly forwards.
• Lift your feet off the footrest platform and stand up using the armrests to provide you with additional stability
if required. (Do not put your full weight on the armrests)