16 Liteway Balance & Liteway Balance Plus Scooters Owner's Manual and Service Record
Assembling your Scooter following Transportation
After removing your scooter from a vehicle and placing it on level ground,
check it is undamaged before starting to assemble it as follows:
1. Undo the knurled knob, release strap and raise the tiller into the
upright position and secure by tightening the knob.
2. Attach the transaxle assembly to the rear chassis by lifting the
rear chassis, and positioning it over the transaxle ensuring that the
front hooks engage on the rear chassis spigots.
3. Manoeuvre the front part to join the rear chassis, aligning the hooks so that they go over the rear
cross bar and the pivot points are aligned. (This stage only applies to the Liteway Balance Plus).
4. Lock the chassis together by stepping gently onto the foot rest until the chassis clicks into place.
(This stage only applies to the Liteway Balance Plus).
5. Refit the under-seat basket, ensuring it is secure.
6. Refit the battery box, sliding it gently down the guides until it is securely in position.
7. Lift the seat and install on the rear chassis ensuring it is fully engaged, and does not rock or rotate.
8. Tiller adjustment: Adjust tiller back into a comfortable position for driving.
Finally check the scooter is not damaged and it is properly assembled, checking that the battery indicator shows
the battery is charged, and the finger controls operate correctly. You are now ready to drive the scooter away.
Warning! Assembling the scooter involves lifting and handling heavy parts. The Liteway Plus Scooters
have been designed to be easily assembled. Your dealer should advise you on the best way to assemble
your scooter.
Warning! Pinching or Crushing. Be careful to avoid being pinched or having your hands crushed when
lifting or handling parts. Wear gloves whenever possible.
Warning! Never unload your scooter on sloping or uneven ground. It could run down the slope and
injure someone.
To Next Page
Loading...
