EasyManua.ls Logo

Electric Mobility Liteway Balance - Freewheel Device; Brakes

Electric Mobility Liteway Balance
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9
Charging Point: The charging point is situated on the battery box either at the side or just below the handle at
t
he rear, depending on the type of battery box fitted. (see Battery Charging section for further instructions).
Freewheel Device
When the vehicle is switched off the brakes are automatically
e
ngaged. This is called “Failsafe Braking”. Also, if the batteries are
flat, the brakes are applied. There may be occasions where you may
wish to move the vehicle without power. To do this there is a
Freewheel Device fitted.
The Freewheel device allows the vehicle to be pushed without power.
To activate, first locate the lever. When standing behind the scooter, it
is located on the right hand side of the rear of the vehicle - See Illustration.
Make sure the ignition is switched off.
Move the lever FORWARD The vehicle can now be pushed in Freewheel.
Move the lever BACK to engage drive. The vehicle is now braked. This is the normal operating position.
IF YOU ARE NOT COMPLETELY SURE OF THIS FEATURE CONTACT
YOUR DEALER BEFORE OPERATING THE SCOOTER.
NOTE: To avoid excessive strain on the tiller / handlebar assembly, never push or pull the scooter in
freewheel mode if a user is on-board. Push the lever FORWARDS to engage freewheel mode. Pull the lever
BACKWARDS to engage Drive mode.
Warning! If the freewheel devices are in “freewheel” mode the braking is disabled. Never select the
freewheel mode if the Scooter is on a slope or could be pushed onto a slope.
Brakes
There are 2 braking systems. The first works with the finger controls. When the finger control is released the
scooter will automatically brake and bring the scooter to a stop. When the scooter stops the automatic
brake will engage. This will stop the vehicle rolling forward or backward. When you start the brake will
automatically disengage. If the battery should go flat the brakes automatically engage. Note that even when
freewheel is selected, a secondary braking system is applied automatically to limit the maximum speed. You
may notice this system when moving the scooter in freewheel.
Warning! If the freewheel device is in “freewheel” the automatic braking is disabled. Never select the
freewheel device if the scooter is on a slope or could be pushed onto a slope.

Related product manuals