ElectrIQ 500CAM - Button Functions; Power Button; Camera Button; Reset Button

4 of 14
20. GPS/ Radar Detector Module
21. USB Port
22. Sticker/Suction Mount attachment
23. Camera Holder
Accessories:
Car Charger x1
Sticker x1
Suction cup x1
USB cable x1
GPS Module x1 (500GCAM only)
BUTTON FUNCTIONS
Power Button – Press this button for 2-3 seconds to turn on/off the device.
Power will only come on if the camera is connected to a power source.
Camera Button – In video mode, pressing the camera button will capture a still
image.
Reset Button – Should the system crash for any reason, press the reset button
to reset the device.
Menu Button – Pressing the menu button will access all the menus for the
camera. If this is pressed whilst the camera is recording nothing will happen.
Stop the recording to access the menus.
File Protection Button – In video mode, when the device is recording, press
this button to set the video recording to be protected manually. This will stop
it from being overwritten by loop recording.