CLEANING AND MAINTENANCE
15
BEFORE ATTEMPTING TO CLEAN YOUR COOKER
WARNING: Isolate the power supply and make sure that the oven is cool before attempting any cleaning or
maintenance.
Do not clean using caustic creams, abrasive cleaning powders, thick wire wool or hard tools. Enamelled parts
of the oven can be damaged if excess cleaning liquids are not immediately removed.
After cleaning the interior parts of the oven with a soapy cloth, rinse it and then dry thoroughly with a soft
cloth. Clean the glass surfaces with special glass cleaning agents. Never use flammable agents like acid,
thinner or petrol when cleaning your oven. Do not clean your oven with a steam cleaner. Do not wash any
part of your oven in a dishwasher.
ENAMELLED PARTS
In order to keep them as new, it is necessary to clean them frequently with mild, warm, soapy water and
then dry them with a cloth.
Do not wash them while hot, and never use abrasive powders or abrasive cleaning materials. Do not leave
anything spilt onto enamelled parts for long periods of time.
STAINLESS STEEL PARTS
These must be cleaned frequently with mildly warm soapy water and a soft sponge and then dried with a
soft cloth. Do not use abrasive powders or abrasive cleaning materials. Do not leave anything spilt onto
stainless steel parts for long periods of time.
CHANGING THE OVEN LAMP
WARNING: The maintenance of this appliance should be carried out by an authorised service person or
qualified technician only.
WARNING: Switch off the appliance and allow it to cool before cleaning your appliance.
NOTE: The lamp is designed specifically for use in household cooking appliances. It is not suitable for
household room illumination.
• Remove the glass lens, then remove the bulb.
• Insert the new bulb (resistant to 300 °C) to replace the bulb that you removed (230 V, 15-25-Watt,
Type E14).
• Replace the glass lens, and your oven is ready for use.
• The product contains a light source of energy efficiency class G.
• Light source cannot be replaced by end user. After-sales service is needed.
• The included light source is not intended for use in other applications.
To Next Page