USING YOUR BUILT-IN DOUBLE OVEN
7
INSTALLATION
NOTE: The oven is built in. The appliance should only be installed by a qualified professional.
• Check the dimensions of the appliance and make sure the corresponding recess is
compatible.
• Never lift the appliance using the door handle, as this will cause the glass to break.
• Place the product in front of the opening and ensure the cable has room to be installed.
• Connect the cable to the mains.
• Put the product into the installation opening. Insert the screws with spaces into the holes in
the front frame and screw the oven into the cabinet. Then connect the caps on the screw
heads.
IMPORTANT: The kitchen unit where the oven is to be situated must be made of heat-resistant
material. Ensure that any panels close to the oven can withstand temperatures of at least 120
o
C. If
plastics or glues that form the cabinet cannot withstand such temperatures, they will melt and
deform the unit.
Ensure that there are no combustible or
flammable materials, such as curtains, in the
vicinity of the installation.
There must be at least 2cm of free space
between the back wall and the appliance's
rear to allow for ventilation and air
circulation.
After making the electrical connections (See next page), insert the
oven into the cabinet by pushing it forward. Open the oven door and
insert two screws in the holes located on the oven frame. While the
product frame touches the wooden surface of the cabinet, tighten
the screws.
To Next Page
Loading...