Need help?Do you have a question about the Electro-Voice CP3000S and is the answer not in the manual?
General| Type | Power Amplifier |
|---|---|
| Channels | 2 |
| Output Power (4 ohms Bridged) | 2200 W |
| THD (Total Harmonic Distortion) | < 0.1% |
| Signal-to-Noise Ratio | > 100 dB |
| Input Sensitivity | 1.4 V |
| Input Impedance | 20 kΩ |
| Cooling | Fan-cooled |
| Power Requirements | 100V, 120V, 230V, 50/60Hz |
| Frequency Response | 20Hz - 20kHz (+0/-0.5dB) |
Instructions for qualified personnel to reduce risk of electric shock during servicing.
Procedures for unpacking the amplifier and information regarding the warranty certificate.
Guidelines for proper installation, ventilation, and environmental considerations for the power amplifier.
Explains POWER, PROTECT, SIGNAL, 0 dB, LIMIT indicators and rotary amplification controls.
Details XLR inputs, sensitivity, pin assignments, and Parallel/Dual routing options for audio signals.
Explains SPEAKON outputs, Bridged Mode switch, and output wiring for various configurations.
Details the Ground-Lift switch function for noise reduction and mains input connection.
To Next Page