Electro-Voice RE3-BP0L-T Installation Manual

RE3
UHF Wireless Safety, precautions, and notices | en 7
Electro
-Voice Installation manual 2018-12 | 01 |
F.01U.362.808
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and the receiver.
 Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
 Consult the dealer or an experienced radio/TV technician for help.
1.4.2 IC (Industry Canada)
Certified in Canada by IC under RSS-102, and RSS-210, and RSS-Gen
IC: 1321A-RE3HHT488, 1321A-RE3HHT560, 1321A-RE3HHT653, 1321A-RE3BPT488, 1321A-
RE3BPT560, 1321A-RE3BPT653.
This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la
classe B est conforme à la norme NMB-003 du Canada.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject
to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.
NOTE: Regarding RE3-HHT-6M (653-663 MHz) and RE3-BPT-6M (653-663 MHz); the use of
frequencies between 653.025 up to 663.000 MHz, please check the Canada’s ISED (Innovation,
Science and Economic Development) website for the current information of the license status of
this band.
1.4.3 Licensing information
Licensing: A ministerial license to operate this equipment may be required in certain areas.
Consult your national authority for possible requirements. Changes or modifications not expressly
approved by Electro-Voice could void your authority to operate the equipment. Licensing of
Electro-Voice wireless microphone equipment is the user’s responsibility, and licensability
depends on the user’s classification and application, and upon the selected frequencies on which it
will operate. Electro-Voice advises the user to contact the appropriate telecommunications
authority concerning proper licensing, and before selecting and ordering frequency bands.
1.4.4 EU (European Union)
The CE Declaration of Conformity can be obtained and downloaded from: www.electrovoice.com
This Equipment is in compliance with the following directives:
 2011/65/EU RoHS Directive
 2012/19/EU WEEE Directive
 2014/53/EU RED Directive
Regarding (applies to) handheld transmitter RE3-HHT-5L (480-524 MHz), RE3-HHT-5H (560-596
MHz), RE3-HHT-6M (653-663 MHz), RE3-HHT-8M (823-865 MHz), and bodypack transmitter
RE3-BPT-5L (480-524 MHz), RE3-BPT-5H (560-596 MHz), RE3-BPT-6M (653-663 MHz), and
RE3-BPT-8M (823-865 MHz):

Electro-Voice RE3-BP0L-T Specifications

General

Brand	Electro-Voice
Model	RE3-BP0L-T
Category	Microphone
Language	English