Service Diagnostics
• Press and hold SELECT and CANCEL buttons
simultaneously for 6 seconds to reset control. The
buzzer will sound 1 time and “rES” will show in the
display.
• Immediately after, rotate cycle selector knob 5 turns
counter-clockwise to the second position from the
bottom. Press and hold the OPTIONS and CANCEL
buttons simultaneously for 2 seconds. The control will
enter test mode, the buzzer will sound 3 times and all
LED’s will rapidly flash.
• After entering the test mode, the cycle selector knob
can now be rotated to select the following tests.
To Next Page
Loading...
