List of Tests
Listed below in order of appearance is each test that can be performed while in
the diagnostic test mode. The program knob is used to access each test.
1. User Interface Test: At this point, all of the LEDs are sequentially flashing, pressing a button
below a cluster of LEDs will light all of the LEDs in that cluster. This test is used to check the
functionality of the LEDs as well as the user interface.
2. Wash Compartment Test: Turn the program knob one position clockwise from the start
position. This will activate the hot water solenoid. At this point, hot water will flow into the
detergent compartment. This test will check the function of the hot water solenoid and the
functionality of the detergent compartment.
3. Bleach Compartment Test: Turn the program knob two positions clockwise from the start
position. This will activate the bleach water solenoid causing cold water to flow into the
bleach compartment. This test will check the function of the bleach water solenoid and
functionality of the bleach compartment.
To Next Page
Loading...
