Demo Mode
To enter the demo mode, execute the following procedure:
Press the Cancel button.
Wake up the user interface by pressing any button on the console
other than the Cancel button.
Move the program to position two (rinse cycle).
Press and hold the Start/Pause and Spin Speed buttons
simultaneously for five seconds. These buttons must be pressed
exactly at the same time to enter the demo mode.
After pressing the Start/Pause and Spin Speed buttons
simultaneously the unit will beep. After the unit beeps, press the
Start/Pause button. The unit is now in demo mode.
This procedure must be completed within 7 seconds from waking up
the user interface.
To Next Page
Loading...
