2. Press briefly. The counter
restarts.
Resetting the counter before the filter
indicator appears:
1. Make sure the hob is switched off
and Child Safety Device does not
operate.
2. Clean the filter and place it back
inside the hood.
3. Press twice. The indicator
appears and the signal sounds. The
counter restarts.
The counter starts automatically when
you turn on the hood for the first time.
The maximum number of cleaning cycles
is 8. After that time, the filter needs to be
replaced with a new one.
WARNING!
An oversaturated filter can
pose a risk of fire.
10. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
10.1 What to do if...
Problem Possible cause Remedy
You cannot activate or
operate the hob.
The hob is not connected
to an electrical supply or it
is connected incorrectly.
Check if the hob is correctly
connected to the electrical
supply.
The fuse is blown. Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali‐
fied electrician.
You do not set the heat
setting for 60 seconds.
Activate the hob again and
set the heat setting in less
than 60 seconds.
You touched 2 or more
sensor fields at the same
time.
Touch only one sensor field.
Pause operates. Refer to "Daily use".
There is water or fat stains
on the control panel.
Clean the control panel.
You can hear a constant
beep noise.
The electrical connection is
incorrect.
Disconnect the hob from the
electrical supply. Ask a quali‐
fied electrician to check the
installation.
You cannot select the
maximum heat setting
for one of the cooking
zones.
The other zones consume
the maximum available
power.
Your hob works properly.
Reduce the heat setting of
the other cooking zones con‐
nected to the same phase.
Refer to "Power manage‐
ment".
ENGLISH 23
To Next Page
Loading...
