22
Maintenance
Interior Cleaning - As Required
1 Disconnect power to the wine cooler.
2 Remove racks if desired, see WINE RACK REMOVAL/INSTALLATION.
3 Wipe down the interior with a solution of non-abrasive mild detergent and
warm water.
4 Rinse with clear water.
5 Reconnect power to the unit.
Condenser Cleaning - Every 3 Months
To remove and replace the grille for access to
the condenser fins follow this procedure:
1. Remove the control knob by grasping the
knob and pulling straight off (see
Figure 25).
2. Remove the screws at each end of the
grille.
3. Remove the grille.
4 Clean the condenser coil using a brush or vacuum cleaner. Do not touch.
5 Position the grille to align the screw holes with the cabinet.
6 Insert the grille screws and tighten being careful not to over tighten.
7 Install the control knob by aligning the flat of the control knob with the flat on
the shaft. Push firmly.
!
CACA
CACA
CA
UTIONUTION
UTIONUTION
UTION
DO NOT touch the condenser fins. The condenser fins are SHARP. The fins can also be
easily damaged.
!
WARNINGWARNING
WARNINGWARNING
WARNING
Disconnect electric power to the unit before cleaning the condenser.
Figure 25
To Next Page
Loading...
Need help?
General
