SOI/TD - PR 32 599 36 01-86
10.5.2 Disabling pulse washing
Certain programmes use the pulse washing system (PW). Using the procedure described below, the Service
Engineer can modify this system so that Ctrl (continuous) washing is used in all those programme which
normally use the PW system. This intensifies the washing action even in delicate programmes.
Disactivation/activation mode
1. Access diagnostics mode (see 10.1)
2. Press buttons S2-S3 simultaneously. The display indicates the status of the function:
[ 0P ] continuous washing “Ctrl”; [ 1P ] pulse washing “PW” active.
3. Press button S2 to activate and disactivate this function:
[ 0P ] continuous washing “Ctrl”; [ 1P ] pulse washing “PW” active.
4. To store the operation in memory: press key S0 and switch the appliance off or wait for 60 seconds
(appliance in selection mode)
10.6 Exiting diagnostics mode
1. To exit the diagnostics cycle, press key S0 and switch the appliance off.
or:
2. wait 60 seconds: the appliance returns to programme selection mode.
To Next Page
Loading...
Need help?
General
